Features two holes at the
head to make the fastening of wires or cables
sturdy and to create a neat presentation by
tying up the loose end.
Mountable
Head Tie
The Mountable Head Tie can
be screwed on or bolted down in order to secure
the bundled harness to panels or other surfaces.
It can be repositioned before final assembly.
Marker
Ties
With intergraded marking pad
below the head.
Provides neat, permanent identification for
wire bundles. The marking pad can either be
heat-stamped or marked with a permanent ink
pen.
With Overhead marking pad.
With intergraded marking pad
along side of the tie. can provide cost-effective
printing on both cable ties and marker ties
(minimum order quantities apply). uses hot foil
stamping to produce fade resistant characters.
Imprinting is available in a wide selection
of characters as well as in various colors on
nearly all cable tie sizes. Logos, and sequential/non-sequential
numbers can also be printed.
Push
Mount Tie
Features a triangular shaped
head that can be pushed into a pre-drilled
hole (4.8mm) to secure the bundled harness
in place.
External
Cable Tie
Sideway locking mechanism,
suitable for outdoor usage.
Material: Nylon 12 (Only available in Pigmented
black).
Temperature range: operating temp. (after the
mounting) -45°C to +80°C ,
mounting temp. -25°C to +60°C .
Inflammability rating: UL 94 HB.
Releasable
Cable Tie
Features
an integrated release tab to allow the
cable tie to remain locked until intentionally
released.
Particularly suitable for situations
where temporary fastening is required.
Easy to use: Push to Release system.
Relievable
Cable Tie
A practical system
specifically developed for the automobile
industry to fasten wires and cables.
It fits in one chassis hole where the
wiring runs. Permits the unfastening
of the cable tie to facilitate the necessary
alterations until final decision.
